Industrial Pipe Coatings
Pipe fails where nobody looks. Under insulation, at supports, at the bend behind the pump, in the stretch that runs through a wet trench. Columbia Industrial Coatings provides industrial pipe coating for process lines, water systems and plant pipework, above ground and below it, from our shop in Richland, Washington, as part of our industrial coatings and linings work.
Industrial Pipe Painting and Coating Services
Some pipe needs paint. Most industrial pipe needs a coating system: a primer chosen for adhesion and corrosion resistance, then build coats and a finish chosen for what the line is actually exposed to. We do both, and the first job on any pipe project is working out which one it is.

Above Ground Pipe
Exposed pipe deals with sun, temperature swings and mechanical knocks. Summer heat in the Columbia Basin cooks a weak topcoat, and winter cycling opens up every pinhole. The usual answer is an epoxy primer for corrosion resistance under a polyurethane topcoat that holds its color and gloss in ultraviolet light. Supports, flanges and welds get extra attention, because that is where coatings break down first. Pipe supports are usually structural steel, and we coat them in the same pass.
Below Ground Pipe
Buried pipe has a completely different set of problems. Soil chemistry, constant moisture and stress from the backfill around it. Coatings for buried service are built for adhesion and moisture resistance rather than appearance, and the detail at joints and transitions decides how long the system lasts. We coat pipe ahead of installation at our shop or in place on site.

Shop or Site
Spools, fittings and fabricated sections can come to our Richland shop. They are blasted in our booth, coated under controlled conditions and collected ready to install, which is how mechanical contractors like Intermech use us. Installed pipe gets coated on site with containment around the work area.
How a Pipe Coating Job Runs
- Survey of the line, the existing coating and the exposure.
- System specified for the environment, not for convenience.
- Surface preparation, usually abrasive blasting matched to the primer.
- Application by brush, roller or spray depending on access.
- Thickness readings and inspection by our NACE Level III inspector.
Where We Coat Pipe
Water and waste water plants, natural gas facilities, irrigation systems, food and juice processing, fuel facilities and power generation. We work across Richland, Kennewick, Pasco, West Richland and the wider Pacific Northwest.
Request a quote for your pipe coating job.
Frequently Asked Questions
Yes. Spools, fittings and fabricated sections can be brought to our Richland shop, blasted in the booth, coated and collected ready to install.
Usually an epoxy primer for adhesion and corrosion resistance under a polyurethane topcoat that holds up in sunlight. The exact system depends on what the line carries and its surroundings.
Yes. Below ground pipe needs a system built for moisture and soil conditions, and we coat it either before installation or in place on site.
Our NACE Level III coating inspector checks preparation and film thickness during the work, so inspection stays in house.